+ КСНУМКС-КСНУМКС

Тандем Геар пумпа

Ти си овде : Почетна >производ >Хидрауличне зупчасте пумпе >Тандем Геар пумпа

proizvodi

  • /img/tandem_gear_pump.jpg
  • /upfile/2019/01/19/20190119154312_240.jpg

Тандем зупчана пумпа

  • опис
  • истрага

The gear pumps are designed for transforming the mechanical energy as energy of the working liquid (pressure and flow rate). They are simplified in construction and they have a relatively low cost. All these benefits ensure their wide application in the hydraulic systems.

Drive arangements :The pump drive may be direct or indirect (by gear, chains, or belt transmissions). Both drives should not impose axial or radial forces on the pump shaft. Oldham coupling serrated drive adapters are used with direct drive. For indirect drive refer to the manufacturer.

The gear pumps are designed to work at the conditions mentioned below:

- Working liquid: hydraulic oils with viscosity 16 ... 200mm2/s;

- Degree of filtration:  15 ... 25ìm;

- Ambient temperature range: - 22 ... 55 °C;

- Fluid temperature range: - 25  ...  80   °C;

- Inlet pressure, absolute:    0.8 ... 2.2 bar;

- Fluid velocity (suctiun line) 0,5 ... 1m/s

- Outlet pressure up to 250bar.

 

The gear pumps made by “SJ TECHNOLOGY” are produced in 5 different groups: 00, 10, 20 and 20H, 30 and 40. The displacements  of the pumps are in the range  from  0.25 to 60 cm3.

Group 00 q = 0.25 ...2 cm3;

Group 10 q = 1 ... 9.8 cm3;

Group 20 q = 4.5 ... 25 cm3;

Group 20H q = 15 ... 36 cm3;

Group 30 q = 20 ... 60 cm3;

Group 40 q = 46 ... 60 cm3.

 

There are different variants of flanges, shafts and ports for each pump group (standard; Germany; USA ...).

Iнкуири
  

ПРИЈАВИТЕ СЕ И УШТЕДИТЕ!Ексклузивне понуде путем е-поште и посебна понуда са попустом

Упитна корпа
празанистрага